CCNP

Step By Step EIGRP Configuration Example

Posted on
eigrp configuration

After overview of EIGRP , it is time to take a look at EIGRP configuration. EIGRP configuration is really awesome and not so hard if you compare with OSPF or etc. Let’s take a look to figure below and configure this topology via EIGRP step by step. Configure the network above with EIGRP using Autonomous system number 90. Use […]

CCNP

EIGRP Over NBMA Configuration Basics

Posted on
eigrp over nbma example

This configuration is an example of EIGRP Over NBMA configuration. EIGRP Over NBMA is a form of EIGRP configuration. 1) Configure EIGRP with AS 25. 2) Each router should make summarization to decrease the routing table. 3) Make the configuration for that EIGRP uses %30 more bandwith due to default config. ( On the serial […]

CCNP

BGP Neighbor Configuration Explained

Posted on
basic bgp config example

BGP neighbor configuration, is the first step about configuring BGP. Neighbors are manually configured at Border Gateway Protocol. It takes about 60 seconds to establish a BGP neighbor adjecency. ( can be verified by “sh ip bgp summary” command ) IGP : OSPF , R1 Loopback : 1.1.1.1 , R4 Loopback : 4.4.4.4 R5(config)# router bgp […]

CCNP

BGP Configuration Example : Configuring BGP

Posted on
basic bgp config example

Configuring BGP is a little bit different from other protocols, this  BGP configuration sample helps you deeply to understand the BGP configuration. First, you need to make BGP Neighbor Configuration then you must advertise the networks. BGP Configuration Example will be examined with the figure below : There are two ways of sending the routes to BGP […]